Voco Solobond M Bottle

FEATURES

• One component – one application
• Excellent adhesion
• High material elasticity and permanently tight margins
• “Stick-immediately-effect” for easy application of the restorative
• Universal for all light-curing restoratives

DESCRIPTION

Solobond M:

Light-curing universal one component dentine/enamel bonding agent

INDICATION:

• Direct restoration of all cavity classes with all light-curing restoratives in total-etch technique

KEY SPECIFICATION

• Tightly close Solobond M bottles after use.
• Store at temperatures between 4°C – 23°C (storage at 5°C – 8°C prolongs the shelf life of the product).
• Do not expose Solobond M to direct sunlight

PACKING

• 1 x 4ml Bottle

DIRECTION TO USE

Application:

The adhesive bond within the total-etch technique is achieved as follows:

1. Drying Due to the subsequent application of light-curing restorative material, it is necessary to dry the tooth surface. Avoid any contamination of the cavity with blood or saliva. The use of a rubber dam is recommended.

2. Preparation Prepare the cavity according to the principles of the adhesive restoration technique. Areas close to the pulp should be protected with a suitable calcium hydroxide based liner.

3. Etching of enamel margins Etch entire cavity with etching gel (Vococid) starting from the enamel margin (enamel: approx. 20 – 30 s, dentine: 15 s maximum). Remove etching gel by suction, rinse for approx. 20 s and remove excess moisture with an air blower. Do not overdry dentine. The surface should remain slightly moist. The etched enamel should have a chalk-white/matt appearance. If not, repeat etching.

4. Solobond M dispensing Dispense Solobond M onto a Micro Tim or a disposable brush. As an alternative, dispense Solobond M onto a mixing pallet.

5. Solobond M application Apply Solobond M homogeneously to all prepared enamel and dentine surfaces with Micro Tim or a disposable brush and allow to act for 30 s. Then disperse Solobond M with a faint air jet and polymerise with LED/halogen light for 20 s. Do not remove or contaminate the inhibition layer since it is important for the adhesion to the composite.

6.Work the filling material.