Dentsply Calibra Universal Self Adhesive Resin Cement

• Two-component, dual-cure resin cement.
• Contains fluoride for added protection.
• Suitable for a wide range of dental restorations, including metal, PFM, resin/composite, ceramic, and porcelain inlays, onlays, crowns, bridges, and endodontic posts.
• Self-adhesive, eliminating the need for a separate dentin/enamel adhesive bonding agent or system.
• Wide tack-cure window of up to 10 seconds for precise placement.
• Extended 45-second gel-phase for easy cleanup.
• High radiopacity for clear visibility of restoration material within the crown.
• Available in five esthetic shades: translucent, bleach, light, medium, and opaque.

Key Specifications

• Composition Two-component, dual-cure resin cement with fluoride.
• Applications Suitable for metal, PFM, resin, ceramic, and porcelain inlays, onlays, crowns, bridges, and endodontic posts.
• PRE-TREATMENT Follow dental lab or restoration’s manufacturer’s directions for pre-treatment of the intaglio surface of the restoration, if required
• APPLY CALIBRA UNIVERSAL CEMENT Dispense and discard a small amount of material from the dual-barreled syringe. Attach mixing tip. Apply a thin, uniform layer of Calibra Universal Cement to the entire intaglio surface of the restoration.
• SEAT RESTORATION Protect restoration from contamination and movement until the final set of the cement (6 minutes from start of mix or completion of light curing)
• Working Time Tack-cure window of up to 10 seconds for precise placement and a 45-second extended gel phase for easy cleanup.
• CLEAN UP EXCESS: SELF CURE The excess cement will reach the “gelled” state after approximately 1-2 minutes in the mouth. Excess cement will remain in the gelled state for approximately 1 minute.

Packaging

2 x Calibra Universal syr (4.5gm each)

Directions to Use

Preparation: Prepare the tooth structure and the restoration according to standard dental procedures. Ensure that both are clean and free of contaminants.

Mixing: Dispense the required amount of Calibra Universal Cement from the dual-barreled syringe. Follow the manufacturer’s recommendations for the appropriate ratio of base and catalyst. Mix thoroughly for the recommended time to ensure proper activation.

Application: Apply a thin layer of the mixed cement onto the internal surface of the restoration. Ensure even coverage.

Seating the Restoration: Carefully place the restoration onto the prepared tooth structure, ensuring proper alignment and fit. Apply gentle pressure to seat it firmly.

Excess Removal: Any excess cement that squeezes out should be removed promptly using dental instruments. Pay special attention to interproximal areas and margins.

Light-Curing: Calibra Universal Cement may require light curing, depending on the clinical situation. If needed, use a curing light to polymerize the cement according to the manufacturer’s instructions.

Cleanup: During the gel phase, which lasts for approximately 45 seconds, you can perform any additional cleanup or adjustments as necessary.

Final Check: Verify the restoration’s occlusion, fit, and esthetics. Make any final adjustments if required.

Post-Operative Care: Provide post-operative instructions to the patient, including proper oral hygiene and care of the restoration.

AVAILABLE IN VARIOUS SHADES